Cleaning Mode

Definition: This function disables a lane from being open while being cleaned by an employee before renting it to another group.  It can be enabled automatically if it is configured in the open-play sets of lane options or league-play sets of lane options.  It can also be enabled manually from the All Lanes window in case a big unexpected mess needs to be cleaned up.

How to enable Cleaning Mode manually:

1) Go to the All Lanes window in Conqueror and select the lane that needs to be cleaned.

2) Click Services in the control panel at the bottom.

3) Click Cleaning Mode and confirm by clicking OK.

4) The lane shows a sign that the lane is being cleaned and the opening buttons are absent.

How to restore a lane:

1) Go to the All Lanes window in Conqueror and select the lane that was just cleaned.

2) Click Cleaning Mode in the control panel at the bottom.

3) Click OK to restore the lane.

4) The lane goes back to a CLOSED state and it can now be open as normal.

How to enable Cleaning Mode automatically from a set of lane options (open play):

1) Go to Setup > Bowling Setup > Lane Options.

2) Select a set of lane options on the left.

3) In Bowling / Lanes Services (3rd tab), select Cleaning mode after lane closure.

4) Click Save and click the X to exit out from the page.  You may also select another set of lane options on the left.

How to enable Cleaning Mode automatically from the set of lane options (league/tournament play):

1) Go to Quick Access > League Control/League Management.

2) Select the league from the list and click OK.

3) Go to Settings > Technical > Options.

4) In Bowling / Lanes Services (3rd tab), select Cleaning mode after lane closure.

5) Click Set to league at the bottom right and click every X at the top right to exit out from the league pages.